Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 20 of 84

    Hybrid View

    1. #1
      Join Date
      Oct 2012
      Location
      British Columbia
      Posts
      614
      Country Flag: Canada
      Quote Originally Posted by jlcustomz View Post
      Todd, just posted on the bodyfiller thread again & viewed your link. The usc all metal filler is superior for an initial coat of filler in welded/ less than perfect areas, such as the top line you want crisp. You could have to stiff wire brush back to bare metal near the needed area to use it. It's basically a fiberglass/ ground aluminum formula, requires a bare metal base , does not apply or sand as easy as some finishing product & will need a skim coat of quality filler/ glazing for a final coat.
      As far as sanding &shaping the upper edge , you just have to apply extra filler to the edge, block from 1 direction, then the other keeping your sanding stick flat near the edge till you achieve a square edge. then you have to carefully remove some of the squareness, which is the most artistic part of the job. A basic paint stirring stick can be a good basic sandpaper holder if you don,t have a fancy selection of stuff. At the end of the day , your skill itself is the most important tool.
      You may be just fine continuing with the filler you're using, especially if you welds are continuous & solid. It just won't be as solid in a thicker area, especially if if gets hit with a falling wrench or something,your call there.
      Hope this helps you some .You can pm me if you need to.
      Thanks jlcustomz for the great information . I've decided to take a break from the firewall and then go at it again later on to finish it off. Here is the body stuff that I used on the car so far.
      Name:  IMG01563-20121027-1258.jpg
Views: 7050
Size:  94.1 KB



      And here is the primer that I used;
      Name:  IMG01564-20121027-1259.jpg
Views: 7050
Size:  109.4 KB

      My only other thought is to use a filler primer when I get close to painting it but that will not be until Spring, I also watched some YouTube videos of guys shooting some black guide coat and blocksanding to find the low spots. I am now getting the car on the rotisserie and will start working on the bottom;
      Name:  IMG01566-20121027-1557.jpg
Views: 7138
Size:  101.8 KB

      Last week I sent my TCI frame to the powder coat shop and should have it back in a couple weeks. After that my 350 goes to Richmond Engine in Langley to get broken-in and Dyno tested and then I can start the assembly on the drivetrain. Updates will now start coming much more slowly as it really isn't very interesting to see me cleaning and scraping the bottom of the car. In the Spring I'll order the TCI rear suspension and hopefully get the car back into rolling status.
      Todd
      '14 ZL1, 6 speed and 6.2L of Super Charged Awesome!
      '67 Camaro SS in process. A long, slow, expensive trip...


      How hard can it be...

      Project Obsession
      https://www.pro-touring.com/showthre...ject-Obsession





    Advertise on Pro-Touring.com