Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 18 of 18

    Hybrid View

    1. #1
      Join Date
      Aug 2004
      Location
      Holly, MI
      Posts
      264
      There are two wires that connect between the EDIS module and the Megasquirt system. One wire carries the position signal from the EDIS module to MS, and the other is the SAW from the MS to the EDIS that tells the EDIS when to fire the coils. The system may be complex, but adapting it to a car is easy.

      The MSD distributor plug can be had with or without a cam sync signal (at least for a Chevy). I bought the one with the signal in case I want to go sequential in the future. It still sticks out of the manifold a few inches, but the small diameter would allow you to move the engine back.

      One of the big advantages of the COP is the ability to put the coils close to the cylinder. With a system like the EDIS, you do get rid of the distributor, but you still need to mount two of the coil packs somewhere and run wires back and forth across the engine. It would be a lot cleaner to mount individual coils on or near the valve covers and have short wires to the plugs.

      Ken

      69 Camaro
      427, 4 speed, TTII's, Konis, JL8 clone brakes, solid AL body bushings, some assembly still required

      69 Corvette
      427, 4 speed, TTII's, Bilsteins, HEI, what I work on while the Camaro sits


    2. #2
      Join Date
      Feb 2005
      Posts
      198
      I looked at the Ford EDIS system over the weekend and it is basicly a batch fire system. It and the electromotive unit are practically the same thing.

      you will need something to drive the oil pump and fill the hole in the block so it might as well be a synch plug. AEM make them also.
      It appears it is not possible to run Sequential w/o a cam sync signal. Even the GM LSx ECU gets a cam sync signal from somewhere. And I had completely over-looked the oil pump I was so focused on the distributor itself. I will probably buy a MSD plug w/ the cam sync signal and run sequential that way. Thanks for all the help,

      Mal

    3. #3
      Join Date
      Mar 2008
      Location
      Mass.
      Posts
      13
      Hi everyone,

      Does anyone have a good understanding of MSD's DIS-4 ignition system? Can you wire four MSD Blaster II coils to be triggered by the DIS-4? This is going into a 95 Mitsubishi Eclipse AWD drag car. It is experiencing terrible misfires at high rpm (7500+,) and so far we have come out empty in finding a solution. It currently has a Coil on Plug setup with MSD DIS-4 ignition. We have the plugs closed down all the way to 0.022" and it still misfires. Boost is set to 34 psi. We swapped the Coil on Plug setup to the stock Coilpack and NGK wires, no change. We change plugs every round to eliminate them from the equation.

      Will those Blaster coils even work on a high rpm setup? I am guessing we can't put out enough spark energy to overcome the high boost in the combustion chamber, and figured if we setup a strong spark source, we might resolve the problem.

      Any other alternatives you guys can think of?

      Any ideas, jokes, flaming welcome I know the car is not a Pro-Tourer, but figured you guys can come up with some ideas.

      The car is running in the high 10s at 130+mph breaking up, and it is driving us nuts

      Thanks
      Panos
      1974 Trans Am - stock
      1994 Eagle talon - drag car project
      1988 Jeep wrangler - Chick magnet




    Advertise on Pro-Touring.com