Results 1 to 19 of 19
Thread: Rack & Pinion Fitting Question
Threaded View
-
10-23-2008 #10
Registered User
- Join Date
- Jan 2005
- Posts
- 29
Thanks Matt. I was looking for a fitting with the o-ring under the hex but I didn't see one. I'll try what you suggested but I'm fairly sure that I have metric threads. The threaded plastic plug that came in the port on the R&P had 14X1.5 stamped on it but then again that could be incorrect so I'll check again. Is it possible to use a fitting without a o-ring and seal the interfacing threads with teflon tape or is that a no no since it is a high pressure application?
-
Reply With Quote
