Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 20 of 22

    Threaded View

    1. #7
      Join Date
      Aug 2004
      Posts
      194
      The 3800 is a 90 deg engine, but it has the 60 deg v6 bellhousing bolt pattern.
      3.8's have the BOP pattern.

      The 60 degree v6 has the starter on one side for the rwd applications and the other side for FWD cars to clear the halfshafts.
      The 3800 is supposed to have the starter on the drivers side of the motor like a FWD car even in RWD applications. (I haven't had to change the starter in one, so I can't verify that.)

      The T-45 in the f-body 3800's is a strange mix of Ford and GM parts and you can't swap the bellhousing from one to a t-5. (the bellhousing to trans pattern is ford) But it has the F-body traits of a rotated bellhousing mount pattern and trans mount pad being at a different angle.

      So your options are:
      Use the F-body transmission and make it fit.
      Use an s-10 trans, but see if the 2.8 starter will work if you drill and tap mounting holes on the passenger side of the 3800 block. (I've seen s-10 3.4's used in fwd cars this way.)
      Use a different transmission altogether and have an adapter plate made. You may also have to notch the bellhousing of that trans to clear the starter.

      Northstars should be priced about the same as the 3800's, it has the same bolt pattern as the 60 degree v6, but the starter is in the "lifter valley" (instead of the lifters, being a quad cam engine and all) and all you need to hack out of the bellhousing is a tiny chunk at the top so the starter pinion can engage. Plus you get 275-300hp. Expect to use an aftermarket EFI setup, though.



      Have you looked at GenIII v8's out of newer trucks?





    Advertise on Pro-Touring.com