Results 1 to 20 of 29
Thread: Disc conversion nightmare
Threaded View
-
09-03-2007 #2
Registered User
- Join Date
- Mar 2005
- Location
- Just North of NYC
- Posts
- 312
I can't tell from your post whether the 'vette M/C was used previously when you had rear drums. If it wasn't, make sure it has the same pushrod depth as your orignal m/c, as this can drastically change pedal feel. Also, make sure the new M/C had a bore no larger than 1"; manual brakes need one inch or less bore to stop a 4 wheel disc car well.
But it does sound like you still have air in the system. Technically you don't need the residual valve, and the prop valve should be adjustable to dial in the balance, but neither should affect your pedal firmness. (Most "systems" stock or aftermarket have about 50% more piston area in the front to act as a built in proportioning valve, so you will likely need an adjustable prop valve.)
Perhaps you need to bench bleed the M/C and then chase the corners again looking for air.
-





Reply With Quote



