New RX7 project

[andrewb70]

Busy morning and early afternoon so far.

Install the flywheel and torque to 107 lb/ft in a star pattern:



Clutch cover, flipped upside down:



Pressure plate added making sure everything is ultra clean:



Then the disk:



This is what a real clutch alignment tool looks like:



Alignment tool inserted. Disk lined up. Clutch cover tightened to 24 lb/ft with a dab or red locktite:



All done. The whole assembly with the flywheel and clutch is about 22 pounds:





After installing the clutch I double checked my setup height to make sure that the throw out bearing was in the proper position. Everything looked great. Transmission was attached to the engine and the engine is in the car. I will take more pics later.

Andrew