Engine Position-Tech Help Needed

[andrewb70]

1 1/4" engine setback won't make a damn bit of difference. I would opt for stock longitudinal location and down some.

I would think that 1 1/4 inches would make a difference considering your moving the transmission back the same distance.

Andrew

[Ron S]

You may want to check header clearance before you make a desicion.That was the problem I found.Some mounts aren't real generous with steering box and frame clearance

[Patrick]

You may want to check header clearance before you make a desicion.That was the problem I found.Some mounts aren't real generous with steering box and frame clearance

I am using the Holley/Hooker Long Tube LS1 headers which clear with either set of plates, however they are really tight with the S&P mounts (I had to demple one tube to clear the pitman arm). Clearance with the Holley Plates is not an issue.

I am just trying to determine which set offers better overall weight distribution.

[paul67]

The plates that move the engine back.

[jannes_z-28]

In the installation guide for LS1 engines that GM sells (#88959384) they have a drawing showing how the engine mounts should be located to get the backplane at the same location as an CSB engine.

From seeing pictures of the Hooker plates I believe that they have done them according to the GM spec.

The S&P plates are done the "easy" way and using one existing bolthole in the block and therefore moves the engine/trans forward.

Jan

[ProStreet R/T]

In the terms of overall effect keep it LOWER.

When you look at the change in weight distribution by moving the engine back 1 1/2" it doesn't do a damn thing. By comparison moving the battery to the trunk has a far more profound change in weight balance. To see any major benefit you need to move the engine 6-8" rearward.

[nitrovette]

The plates i got for the vette put my motor 1 1/4 inch forward,so i had to move my 700 forward and remake the crossmember.The thing was i modified my hooker sidepipes to fit ls1 flanges ,when finished the sidepipes came out right in the right location,if i had set the motor back the 1 1/4 inch they wouldve been jambed up against my rear tires,so it helped me by using them.