The C5/10

[bbalch404]

So I am finally getting around to uploading some more pictures of the progress so far. I have been working on the chassis a lot more. Got all of the laser cut pieces and began the long process of getting them all bent up.







I don't have a break so when the parts were cut, where ever there is a bend we put a small cut. I used this cut to not only make the bends able to be done by hand (with some clever clamping and leverage solutions) but also to make sure the bends are done in the correct location. These will all get welded up during assembly.













Once they are all bent they will get welded up and then attached to the frame in the locator holes and welded up.







That is pretty much where I am at now. I have all but a few pieces of the chassis and then I will be ready to tack up then fully weld everything. Hope to have a rolling chassis by spring.