67 Roush Supercharged Coyote Mustang

[Restocreations]

I've been working on the hood the last two days.

As i stated previously, i had to raise the hood scoop 1-1/4" to clear the supercharger.



Yesterday I started grafting in material where there were voids at the three connecting points/spears on the front of the scoop. I also cut the rear section loose from the underlying hood surround support.
First step after cutting out the rear ledge of the hood scoop was to make and area that i could bond material and resin to. I used paint stir sticks wrapped in tape to provide a dam to keep the kitty hair filler in place. I had to make the ledge on the back and the sides.

Here is the back ledge i created after the stir sticks were removed.

[/URL][/IMG]

I then used fleece and resin to make the new rear piece of fiberglass that will sit under the scoop.
Here is what the hood looks like now that the spears or nostril bones are connected to the top of the scoop again. It's turning out much better than i originally thought it would.