Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 20 of 22

    Threaded View

    1. #8
      Join Date
      Oct 2004
      Location
      Indiana
      Posts
      1,371
      Quote Originally Posted by jlwdvm View Post
      My 69 Trans Am clone project is getting to the point where I have to start making decisions on rear end, wheels-tires, suspension, etc. I an finishing up installing a Chris Alliston 6-point roll bar. I already mini tubbed the car this winter. It has an 8.5" rear in it at the moment that will probably be changed out to something that can handle 500+ Pontiac horsepower. I'm thinking about a full ridetech front and rear suspension kit with coil-overs. I will be using a stock front sub frame. Questions are: Do I run a stock width rear if I want 335 tire; are there tire width limitations since the lower control arms bolt up where the stock leafs would on the rear end; what size of tire could I run without adding true-turn, does the narrowed frame rails affect the rear 4-link attachments? Any other input would be great!
      On the front:
      If you are going to NOT use the Tru Turn system you will be limited to a 245mm tire on an 8" rim with a 4.75" backspace. If you use the complete Tru Turn system [an extra $650] then you can go up to a 275mm tire on a 10" rim with a 5.75 backspace. AND...you'll have much better overall frontend geometry by optimizing the bumpsteer.

      On the rear:
      There is one corner of the AirBar cradle bracket that must be rounded off because it overhangs the typical minitub by about 1/4". It'll take you about 20 seconds with a grinder. The lower AirBar control arms are offset to the inside by about 3/4" on each side so they will clear a 335mm rear tire. If you are buying/building both a new rearend and new rear wheels then you have lots of latitude of the width of each. BUT you must coordinate those dimensions. Start with the wheels, then get the rearend built to match the offset of the wheels.
      OR...if you already have a rearend, then get the wheels built to work with the width of the rearend.
      The constant in the equation will be the position of the outer fender lip and the inner wheeltub. Spend lots of time measureing.

      Bret Voelkel
      Director of Innovation Fox Powered Vehicles Group
      Founder/ Former Owner
      RideTech/Air Ride Technologies, Inc.

      How do you spell Impossible?





    Advertise on Pro-Touring.com