Results 1 to 12 of 12
Thread: Rattling P/S pump
Threaded View
-
06-18-2009 #11
Registered User
- Join Date
- Mar 2005
- Posts
- 345
To finally close this thread out, I had some time to look over the pump that didn't pump. This one had the guts from an '85 in it.
I also had a '67 pump on hand to compare it too.
There is only slight differences between the two pumps. The pump casting on the '85 had two holes side-by-side drilled through to feed oil to the outlet port. Where the '67 had a single slightly larger hole for the same feed.
Other then that the pump casting was the same. Same casting number and nearly the same machining.
Pump: the only difference is that the '85 pump has thinner vanes, and a very slight difference in the pump cam shape. The difference in pump cam shape can't be seen unless the two pump cams are placed on top of one another (it may also be that the '67 cam has more wear).
The '85 vanes, however, being thinner are lighter. By design the pump feeds high pressure oil to the rear of the vanes. This is done to press them out onto the pump cam. So upon initial rotation the vanes need centrifugal force to start the pumping of oil.
Then once pressure starts to build the vanes are forced out by the oil being fed in behind them. Interesting design. And, is along the lines of what David mentioned about sometimes needing to give a pump some time before it will provide pressure.
Given more time and RPM this pump would most likely had worked. At the time I wasn't sure that there wasn't something else wrong with it. So went back to the one I knew provided pressure.
One item that was added to the '85 pump was a magnet. A small disk magnet was stuck to the casting on the lower portion. About an inch in diameter and 3/16" thick. It ended up in the pump that is on the car now.
a67





Reply With Quote



