Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 12 of 12

    Hybrid View

    1. #1
      Join Date
      Mar 2005
      Posts
      345
      I don't really won't to bring this thread back to top. That means the original fix didn't work. Lasted about two 20-minute drives.

      However, since it has been so long since the latest "fixes." I think I've got it now.

      After the above mentioned changes the rattling returned. The interesting part was that it was a light clicking sound. Just like it was 10 years ago.

      Click-click-click-click-click-click-click-click-click-click. Rapid and light. Just like a P/S pump would be expected to make.

      So: removed the pulleys, removed the damper.

      Drilled and tapped the damper pulley bolts to 7/16"-20

      Drilled out the pulley mounting bolt holes to 1/2"

      Used 3/8" grade 8 washers (3). Bored the openings to _just_ fit a 7/16" bolt. The bolts used are grade 8 SBC flywheel bolts.

      Put Damper in lathe mounted by the hub snout. Mounted the 2-groove pulley and then the 1-groove pulley on the damper. Just snug.

      Using a dial indicator tapped, prodded, and convinced the pulleys to a minimal run out location.

      Worst was something like 24-thou. Was able to get them within 5-thou. Used the dial indicator on both the top pulley surface and lower groove surface. Just trying to get the least run out.

      Then tightened the pulley mounting bolts to the damper.

      Ah, forgot to mention. The bolts had a short aluminum sleeve on them. Between the head and the washers. This was to keep the welding heat and flame off the bolt heads.

      Removed the damper/pulley assembly from lathe. Tig welded the grade 8 washers with the minimal clearance to the pulley. Welded the pulleys to each other.

      The welding was minimal. Enough that I felt it would hold. But not so much that heat distortion or an unbalance would result.

      Pressed the damper back on and installed the pulleys and belts. It has now been a while and no noise. Much better, and I'm hoping the noise stays away.

      Because if it doesn't, then I'm just going to make or obtain a 3-groove billet or cast set up. One way or another I'm not going to put up with the clicking or clacking noise.



      Bob





    Advertise on Pro-Touring.com