Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 12 of 12

    Thread: LS2 Questions

    Threaded View

    1. #2
      Join Date
      Aug 2004
      Location
      Dunwoody, GA
      Posts
      4,983
      Country Flag: United States
      Flywheels will be the same through all the gen3/4 engines. the only one I question is the 6.0 that had a 4l80 behind it, but that does not matter here. A stock LS7 flywheel and clutch fits on an LS1/6/2.

      balancer does not matter but marking before you remove is good practice. Since you are replacing, just pull it off and replace it. You'll have to be careful though as the crank bolt is different than Gen1/2 SBC and it's not common. Look into that more before you get to that point.

      alignment tools are nice but not needed. To align the front simply start all the bolts. Get them almost tight, then put the balancer on. The balancer will center the front cover well enough. I would recommend you get the alignment tool if you mess with the rear cover which you have no reason to.



      To align the oil pan you just need to remember that the bell housing bolts to it. So take a straight edge across the back of the block and make sure the pan sit in line with it. that way you don't have the bell housing bolts trying to bend anything together to create torque. The book will give you a tolerance on what is considered flush.

      Stock LS2 oil pump and timing set up and all you need. If you plan on a cam, Comp Cams does make an adjustable timing setup that is fantastic. It is called Hex-a-just. However, simply sliding a cam in and putting the stock chain and sprockets on is fine.

      The reluctor wheel is mounted inside the engine and has no affect on flywheel. It's purely for the ECM.
      Trey

      "The early bird may get the worm, but the second mouse gets the cheese."
      ~ Jon Hammond

      1979 WS6 Trans Am stock LT1/T56 drive train out of my Formula. BMW M-parallel rims. C5/C6 brakes

      build thread https://www.pro-touring.com/showthre...ghlight=begins





    Advertise on Pro-Touring.com