Control Arms

[Mathius]

I get it your CERTIFIED welcome to the club .I didn't say anything about being impossible .

You might as well have. This is what you said:

If you think your going to weld a intake manifold ,intercooler or 16gauge piping with a spoolgun and end up with the same product now thats a false statement !

The way I'm reading that, it sounds like you're saying that if I say it's possible for someone to do that, then I'm lying or otherwise incorrect.

You said you would get the same results from a MIG not a torch .

I can, but you're reading it wrong. I didn't say use a torch, I said you can do it with a MIG or a torch. Either method will work. TIG is going to be easier, no doubt.

Make no mistake I'm not challenging you to do anything . If you want to waste you time trying to weld 16 gauge tube with a spool gun have at it .

For a guy who already has a $700 MIG and a spool gun, it isn't a waste of time, if he has to put out another $2k to buy a TIG.

Good luck on your control arms you seem to have all the answers they shouldn't be a problem for you .

If I had all the answers I wouldn't have posted in this forum. All I was trying to say is I'm a competent welder, so I'm not lookin for welding help, or someone saying it's too hard.

I need help with the fabrication side of it because I don't know how these things are assembled, particularly where the bushings are installed, and how the grease ports work.

If you're going to post a contriversial (and challenging) statement like you did, you should expect to get called out for it, so don't get upset with me because I said you were wrong.

Mathius