distribution 4 stud power block help

[silvermonte]

You just hook the red trigger wire of your kit to the EFI fuel pump trigger wire, pretty sure it’s blue on the sniper, check the diagram.

Ilikeike and Andrew, your logic and experience are 100% correct. I got the instructions out and laid the wires out to figure it out. Like Ike said the blue wire from the Holley kit will hook up to the Aeromotive fuel kit, and just like that it should be much safer. If I had not asked these questions I would of followed Aeromotive's instructions, and like you said Ike, that pump would of ran full time.