distribution 4 stud power block help

[Tsaints1115]

Do NOT tie the power for your Sniper to any other power source. It specifically needs it's own clean power source.



That being said a good option is a mini relay fuse panel like this:

https://www.waytekwire.com/item/4634...i-Fuse-Panel-/

They're small enough to fit in the glove box. You'll run the key ignition wire to the fuse panel where it will energize the relays when the key is turned but all the real power is located there. The original circuit will only be responsible to energize the relay. Make sure you use relays with a diode. Doing so will mean each ciruit will only see "clean" power with no interference between each one.