My 80 Z Clone Pro Touring in progress

[AngryBird75]

Thank you. I’d love to take a look at your plans in the trunk. If you get a sec please share a pic of those panels.

trying to get some ideas for my formula.

[J. Chris Davis]

Page 1 shows a couple of pictures. I'll try to find some other pictures. I can also get some more pictures of the panels once I can dig them out.

[J. Chris Davis]

Installed some new dash vents.

[J. Chris Davis]

Here are some older pictures I have of the cardboard panels in the trunk. I don't have plans on them as of yet. These were just keep cutting cardboard till it fit properly then throw some carpet on it. It was always meant to be temporary till I built new panels. I am a little ways off from starting on the trunk. Once I can get back to where those panels are here in the recent future I can get some further pictures of the panels.

[J. Chris Davis]

Kick panels installed. Dash and gauges almost fully installed. Should have that done tonight.

[AngryBird75]

Thank you for sharing.

[J. Chris Davis]

Dash is installed and finished.

[kawasakii]

Any details on how you did the trunk? Very nice work.

[J. Chris Davis]

The trunk isn't finished. Those were older pictures I posted for another member. I just made some panels out of cardboard and put carpet on them in the pictures.

[J. Chris Davis]

Another update. Got the driver door finished.

[AngryBird75]

Looking perfect!

Did you put kilmat inside the door as well?

[kawasakii]

Clean car! Nice job on it.

[J. Chris Davis]

Thank you both! I did not put kilmat inside the door. It is a rough surface and didn't want to risk water getting trapped in there.

[J. Chris Davis]

Passenger door finally done!

[J. Chris Davis]

Another small update.



Got the carpet in and cleaned. The switch holes are made in the console compartment for the USB, parking brake switch and trunk release switch.

Also got the radio installed in the console and the console installed.

​Working on putting in the seats next.

[boss_hoss]

Another small update.



Got the carpet in and cleaned. The switch holes are made in the console compartment for the USB, parking brake switch and trunk release switch.

Also got the radio installed in the console and the console installed.

​Working on putting in the seats next.

Is that a garage door opener on the dash? Thats pretty awesome. How did you wire that up.

[J. Chris Davis]

That is a Homelink garage door opener from early 2000's. It only has a power and ground hookup. No other wires.

[J. Chris Davis]

Rear seats and seat belts installed. Working on the front seats next.

[J. Chris Davis]

Seats, floor mats and sill plates are in. I need to either replace my shift arm or try to heat it with my torch and bend it back about an inch or two so it clears the console in 2nd and 4th.

Then that should finish the interior.

[boss_hoss]

That is a Homelink garage door opener from early 2000's. It only has a power and ground hookup. No other wires.

that’s pretty cool might have to add that to my car. Since most of these cars live in garages most of the time this would be a pretty handy add on.