Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 3 of 3
    1. #1
      Join Date
      Aug 2012
      Posts
      4
      Country Flag: United States

      Quicktime/pontiac/tko?

      I thought I used to see The Quicktime Bell part# 8070 advertised to use behind a BOP with a TKO. I acquired one second hand and found that the hole for the bearing retainer is too small.The man I bought it from had used it with a TKO600.The transmission I currently have is a Mustang 3550 I bought cheap to use for mock-up and maybe fix for permanent use.The retainer measures 7.49(123.19mm) as shown by Tremecs website.The bell bore was approx. .125 smaller OD. I suppose I could bore the hole .060 and turn down the retainer .060 however there isn't much room for either. Since Lakewood has bought them thier website says Ricmond,Muncie,Borg Warner and Chevy TKO.
      Anyone have this problem?
      Thanks,Todd



    2. #2
      Join Date
      Apr 2001
      Location
      The City of Fountains
      Posts
      16,130
      Country Flag: United States
      Quote Originally Posted by TWOCAMAROS View Post
      I thought I used to see The Quicktime Bell part# 8070 advertised to use behind a BOP with a TKO. I acquired one second hand and found that the hole for the bearing retainer is too small.The man I bought it from had used it with a TKO600.The transmission I currently have is a Mustang 3550 I bought cheap to use for mock-up and maybe fix for permanent use.The retainer measures 7.49(123.19mm) as shown by Tremecs website.The bell bore was approx. .125 smaller OD. I suppose I could bore the hole .060 and turn down the retainer .060 however there isn't much room for either. Since Lakewood has bought them thier website says Ricmond,Muncie,Borg Warner and Chevy TKO.
      Anyone have this problem?
      Thanks,Todd
      What you have is not a problem per se but a mismatch of parts. The Mustang 3550 uses a Ford style bearing retainer which is smaller than the GM style retainer. Also, if the 3550 was indeed a Ford style trans the input shaft length and pilot diameter will be different than a GM style TKO (or other older style transmissions).

      Andrew
      1970 GTO Version 3.0
      1967 Cougar build
      GM High-Tech Performance feature
      My YouTube Channel Please Subscribe!
      Instagram @dr__efi
      I deliver what EFI promises.
      Remote Holley EFI tuning.
      Please get in touch if I can be of service.

      "You were the gun, your voice was the trigger, your bravery was the barrel, your eyes were the bullets." ~ Her

    3. #3
      Join Date
      Aug 2012
      Posts
      4
      Country Flag: United States
      Quote Originally Posted by andrewb70 View Post
      What you have is not a problem per se but a mismatch of parts. The Mustang 3550 uses a Ford style bearing retainer which is smaller than the GM style retainer. Also, if the 3550 was indeed a Ford style trans the input shaft length and pilot diameter will be different than a GM style TKO (or other older style transmissions).

      Andrew
      The retainer measures 7.49 OD like all TKO'S. If it were smaller it should fit the bell.
      You are correct about input shaft length


    Advertise on Pro-Touring.com