1969 Camaro "Lillian"

[cwylie]

So after all my trouble trying to low mount an a/c compressor with the holley motor mounts I gave up and ordered a setup from C1 pulleys. I got it all installed only to figure out my NW throttle body would not fit. I reached out to Sean at CBM motorsport and he was really helpful with getting me the pics and info I needed to be somewhat confident in ordering their throttle body. It fit but just barely and I had to take the butterfly out and rotate the shaft 180 degrees to mount the TPS sensor facing towards the rear. The TPS sensor then hit the supercharger snout so I had to clearance it a little but it looks like I have it mostly worked out. Now my problem is the throttle body is close close to the alternator bracket I am not sure how I am going to get a silicone coupler on there.

I thought about possible using one of these but dang they are expensive.

http://vibrantperformance.com/catalo...oducts_id=1628

Im also waiting on a email back from Kevin at C1 as to if he thinks the notch at the alternator could be made a little larger.