Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 14 of 14

    Threaded View

    1. #5
      Join Date
      Apr 2012
      Location
      Lethbridge, Alberta
      Posts
      34
      Country Flag: Canada
      Quote Originally Posted by astroracer View Post
      Be careful moving stuff around. Check out this article from Longacre.
      http://www.longacreracing.com/articles/art.asp?ARTID=13
      The diagram at the end is self-explanatory... Getting the pivots right is critical to the operation of the rack. Also be aware of clearance to the wheel and and stab bar when working this up.
      Mark

      Here's what I've got Mark. I've "strung-up" the suspension and checked that the current rack is giving the correct center to center measurement (21.5") for the inner pivots. Then I've computed the new center line for what I need to clear the oil pan (the ruler bottom edge is on the center line) this gives me 20.75". So to keep the arc in the same plane, I need a shorter rack (pivots move in). The tie rod would ideally have to drop and go out a little. I was thinking that a bump steer corrector with shims should get the job done. It's only 1.5" from the original location. I could buy the steering arm relocation kit, but I'm a little sketchy about a welded steering arm.



      I'm trying to figure out if Coleman Racing or someone else can fab me up a rack or if I should just move the darn engine up (messing up the CG location but making life much easier and a pile cheaper).

      Craig

      Volvo - Tougher than dirt.





    Advertise on Pro-Touring.com