Results 1 to 7 of 7
Threaded View
-
01-15-2013 #5
Registered User
- Join Date
- Oct 2009
- Location
- New Derry, PA
- Posts
- 1,265
One way to get it very close is to measure the locations of the UCA and LCA pivots relative to chassis centerline and ground. This will give you a trapezoid shape \ /
Set your rack height and length so the rack ends fall along the 2 end lines, and the tie rods match the angle of the LCAs.
Sorry if that's a little sketchy...I'm in a rush.
Ray Kaufman - Wyotech Chassis Fab and High Performance Instructor. Words of Wisdom from an old master... at Asylum Custom Interiors website
-
Reply With Quote
