Outer Tie Rod Question

[astroracer]

Well, I don't feel quite as sick as I did a few minutes ago. I talked to Mike (Iron Mike's) in Flint and he said the spindle will definetly be cast steel. Cast iron is too brittle and aftermarket arm manufacturers go with the steel because it's easier to do then the ductile iron most oem's use. He wants to see the arms but he says he has bent steel arms farther than what I need, for 4 x 4 and offroad guys, and had no issues down the road. He thinks it is do-able. I hope so.
In any event I think I will start looking into Corvette spindles and what kind of tear-up those would be to my geometry points...
Even if I have to build new cobtrol arms in the future.
Thanks again guys, you have helped big time.
Mark