Results 1 to 20 of 54
Thread: Video?
Hybrid View
-
07-23-2011 #1
Bill,
I installed an oil cooler and accusump 3 winters ago. The inaugural Motorstate event changed my build drastically. Back then the Mobil 1 I was running thinned out big time. I believe my oil system is up to par, its the cooling system that allowed the engine temp to exceed normal racing parameters. When tracking a car an oil cooler and temp gauge are a must!!
MattMatt
Current project: " Chain Reaction "
A.K.A. " BIG " by wife, biatch in garage.
1969 RS Camaro L92 T56 Quadra-link, CW sub, Ford 9" a progressive build.
Ex track car: 1995 Camaro LS1 T56
-
07-23-2011 #2Matt, you're right. I have an oil temp gauge in my dash, but was hoping to avoid an oil cooler. Motor State had me concerned, though the oil never really got unreasonably hot - assuming I'd change oil after the event anyway. Heidts absolutely convinced me that I need a cooler. The fact that my block is bottom filled to the freeze plugs creates a real oil temp concern. But, it's all a trade-off. I have to essentially fabricate a fixture for my block that can route the lines up and forward without conflicting with the headers, firewall or inner fender. Then I need to change my oil filter setup from the frame rail to forward, then install a couple bulkhead fittings, and figure out how/where to mount the cooler. I also need to determine -10 or -12 lines select the right cooler, and then watch oil pressure to hope that I don't need to put a different oil pump in. Isn't this stuff fun?
'66 GTO Vert Project "Red Ink", 462ci of stroked pontiac power, TKO600, SC&C Stg II+, Tubular lowers, Currectrac Rear suspension, Moser 12bolt w/Truetrack, Wilwood Master and discs all around, too much fun for words...





Reply With Quote




