Results 1 to 12 of 12
Thread: quarter patch panel
Hybrid View
-
06-18-2005 #1
This is something that confuses me as well. I have no experience with 1st gens. I am a 2nd gen guy and I have tried to use the 'store bought' patch panels but find they don't work worth a damn(although I hear some 1st gen panels really are nice). I finally gave up and started spending the time making my own.
From what I understand, it is best to use the whole patch if it is a good quality reproduction, but make sure it is REALLY acurate before you start hacking your car apart. Patch panels are made the way they are so you can use the whole thing, but so far I don't trust them.
I am looking at your pics and it seems that the bad stuff is some pitting towards the rear of the fender. The other day, I noticed on "American Hotrod" that the older metal fabricator (the retired, part-time dude who complains a lot) uses a torch and brass sticks to fill pits after he grinds them out with a Dremmel. Maybe someone on this site can offer a suggestion on whether to do this method instead of hacking apart your car....unless of course I am missing some really bad stuff in the pic.
-
06-18-2005 #2
Banned
- Join Date
- Aug 2003
- Location
- Orlando, FL
- Posts
- 8,745
If you can get away with it, I would use as little as possible below the trunk extension. But it really looks like you have damage well above that trunk filler. I would go about an inch below the body line. Gives you a reasonably firm area to work since the break line is right there, while not jepordizing the body line by trying to butt it or go over it. I would also stop it a inch short of the jamb.
As far as braze, other then the factory, or old timers, braze is hard to get filler to stick to. it has a tendancy to bubble later.





Reply With Quote



