distributorless ignition

[chickn]

MegaSquirt.

Could you tell me more about your setup? I am thinking about doing the same thing. What version of megasquirt are you running? Are going to run in wasted spark mode? or are you planning to using a cam position sensor. MAP sensor, temp sensor,spark tables......?
Thanks

[Ollie8974]

Could you tell me more about your setup? I am thinking about doing the same thing. What version of megasquirt are you running? Are going to run in wasted spark mode? or are you planning to using a cam position sensor. MAP sensor, temp sensor,spark tables......?
Thanks

Is the car in your avitar the car you will be installing the MegaSquirt?
I am running the MegaSquirt-II PCB 3.0 version, with a relay board. This setup has provisions for all the required sensors. This will be installed in a 79 Trans Am, with a traditional 455 Pontiac engine.
I have some 36-1 trigger wheels for sale. They are 7.10 inch in diameter and laser cut. I am using a HEI distributor to fabricate a cam sensor.
This link is to the MegaSquirt site if you have not found it yet.
http://www.bgsoflex.com/megasquirt.html

The original plan was to run wasted spark using an EDIS module. The project is on hold awaiting the arrival of the next batch of MegaSquirt - III Daughter Boards.
The MS-III will permit the use of sequential spark and fuel injection.
The below link is to diyautotune page for the MS-III Daughter Board.
http://www.diyautotune.com/catalog/m...45aa472e76c13a

[chickn]

I plan on installing it my on 69 firebird. I'm in need of something new to play with. I thought it would I would get my feet wet with the ignition side of megasquirt then in the future do EFI. After reading the website, I plan on waiting for ms-III daughter board. Please post your progress.