Unisteer R&P in First Gen with LS1?

[vannatta20]

I finally got the phasing to work! The first two you joints had to be mis phased. The bottom u joint had to be phased 33 degrees only. The steering shaft barley rubs the header so I need to dent the header. I can't dent the header though without using a torch since it is Stainless.....

[LowBuckX]

I finally got the phasing to work! The first two you joints had to be mis phased. The bottom u joint had to be phased 33 degrees only. The steering shaft barley rubs the header so I need to dent the header. I can't dent the header though without using a torch since it is Stainless.....

Your hammers not big enough then lol... Glad you found a solution