Getting closer........

[Jim Nilsen]

Just got done degreeing the cam with the intake centerline method and the cam is right on the money at 109 degrees.

Now it is on to putting it all back together. The rest of the parts I need are on the way and if all goes well I should be starting it up by the end of the week.

I have a new pulley on the way for the alternator drive to speed it up so I have good voltage at the new idle which will be much lower. I am hoping for a 600-700 rpm instead of 1000 rpm idle.

It should be straight forward to put it back together. The geometry seems to be good so far with the lift being so close to the other cam. I should be setting rockers tommorow night and starting to button it up.

Still lots to do but getting it back up and running is on top of the list.