Results 1 to 20 of 28
Thread: Auto Craft LS1 Oil Pan???
Hybrid View
-
11-29-2008 #1
Registered User
- Join Date
- Dec 2007
- Location
- Carlsbad, Ca
- Posts
- 1,213
any pics or description of where the hole is? i didnt even know it was an issue. i havent installed my pan yet, but i would have been screwed.
[hijack]anybody use this pan with a mcleod bellhousing? i know that most bellhousing plates require clearance, but i didnt know if that had been addressed with this pan.[/hijack]
Tim
Tim
The WidowMaker: Garage Built 70 Chevelle
Special Thanks To: Rushforth Wheels, MuscleRodz, Kore3 & SC&C
Build Thread Link
-
11-29-2008 #2
Registered User
- Join Date
- Jan 2008
- Location
- Castro Valley, CA
- Posts
- 530
I tapped mine also. If you dont it will leak. Used a 10mm. I did it with motor out of car.
John S.
68 "Bloodline" Camaro in assembly...
Speedtech Sub, Alston G-Billet/Fab 9 rear, Ridetech coil overs, Moser axles, Fesler 19's, Lots of Anvil parts,Twin tubo LS3/T56, Carbon fiber manifold, and the list goes on and on..........
Reply With Quote
