Exhaust Video Thread

[crustyz11]

Okay, i'm new but here goes, this is my setup so far;
-mild 355 with World heads, Comp Cams 274 cam, Edelbrock intake, Demon carb.
-cheap-o coated flowtech headers w/flowmaster american thunder exhaust.
-stock th400
-original stock 3.08 posi 12 bolt
http://www.youtube.com/watch?v=WqnUWGFvP38

[Vegas69]

Since I started the thread it's time to post mine up.

489 Big Block Chevy Roller 593 HP/ 491 HP on the ground.
2 1/8 lemons headers into 3.5 collector
3 inch magnaflow stainless with x pipe and dumps

[Procharmo]

I'm sure you've seen the vid before but here goes again.

Procharger F1C
Comp Cams #249-12-564-4
Grind: 274
Lift: .488''/.501''
RPM Range: 2400-6500
AFR 195 2.080,1.6 competition heads,
SBC 355, Air Gap rpm, Pro EV hat, 1.6 rockers,
1 7/8" 3.5 collectors Hooker super Comp headers,
QTP 3" electric cut outs, Jegs 3" X Pipe, Jegs 3" over the axle,
Flowmaster 3" muffler, Pypes 3" tail pipes.

[TPI Monte SS]

Here's a vid of my Monte. It has a 355 V8, 9.8:1 compression, and ZZ4 cam. Exhaust is Edelbrock TES 1 5/8" headers into a single 3" test pipe, then split out into 2 2.5" pipes with Hooker Aerochamber mufflers. You can hear the idle and rev at the end of the video.

[Curley]

What the hell, here is mine. 383 with Thorley tri-y headers 1 5/8 primary to 2 1/2 collector, h-pipe, flo-pro mufflers to full 2 1/2 over and out the rear.

[67speedfreak]

Here is a vid of Agent Orange.

650 HP 502 with 2 1/8 dougs headers and custom 3in w/flow masters.

http://www.youtube.com/watch?v=rJdLIS2JF_0

[ponchopwr70]

Heres my car with 3" oval x-pipe with small spintechs and 3" tails, with a 388 chevy, engine specs are in my pt garage http://www.youtube.com/watch?v=SER1gBLn2N0

[7DRRunner]

70 Road Runner

440 4bbl

don't know the specs on the bumpstick

headers

Dynomax Ultra Flows 2.5"

just blowing out some condensation after a long winter's nap


http://www.youtube.com/watch?v=HwqUe2HDXhE