Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 20 of 681

    Thread: Project FNQUIK

    Hybrid View

    1. #1
      Join Date
      Aug 2004
      Location
      Mapleton, IL.
      Posts
      252
      Country Flag: United States
      Really nice build Wayne. I have engine envy��. Hope the doc gives you the green light. Don't sweat how long it's taking I'm slow too.



    2. #2
      Join Date
      Nov 2006
      Location
      Ma.
      Posts
      5,560
      Country Flag: United States
      Hi Did a little work on the car we pulled the motor out and notched the frame for the A/C. First made some estimate tape marks.



      Then we removed the motor and broke out the air tools and started cutting.



      Then these cuts





      We'll fill in the small cut out first then do the final pocket for the Compressor with 1/8" or 3/16" plate.

      We also did some work on the remote oil adapter for the hoses. I was going to come straight down with orb to AN fittings then 90 towards the front. But the kick out on the AutoKraft oil pan and my headers were closer than was feasable. We decided to put an orb to An close 90 in the adapter and go above the bump out on the pan with the outlet hose and down then forward with a 120 degree on the return line.
      The pan I got was used and the original owner had it powder coated and left the spot where the O Ring sit to seal the adapter bare. This made a lip of thick powder all around the o rings and I didn't think would seal very well. So I removed the adapter and stripped all the powder coat under where the adapter sat to even it out with where the o ring went. While we had it off my buddy Spaceman cleaned up all the sharp edges on the inside of the adapter to help with flow. so when we are ready to put the motor in we can seal up the adapter and be ready for the hoses.







      Wayne
      Car FINALLY home !!!!!! lol
      Project FNQUIK https://www.pro-touring.com/showthre...ghlight=FNQUIK

    3. #3
      Join Date
      Nov 2006
      Location
      Ma.
      Posts
      5,560
      Country Flag: United States
      Well my buddy that helps me with the car pulled something in is neck and been out of action for over a week so I'm doing small stuff until we can get his welder down here to finish the frame notch.
      I made up some braided hose for the steam line which will go to the Finch hose reducer with a line taped in. I'll make the final hose once I can measure it when the motor is back in the car. Boy it's a tight squeeze going between the Super charger and the water pump, But I got it in.







      The only thing is in the last picture the hose is just about touching the water pump so I'll need to put something to protect the hose. (if I can get it in there.)
      Wayne
      Car FINALLY home !!!!!! lol
      Project FNQUIK https://www.pro-touring.com/showthre...ghlight=FNQUIK




    Advertise on Pro-Touring.com