Results 1 to 8 of 8
Thread: Engine ID number decoding?
Threaded View
-
11-20-2006 #6
Registered User
- Join Date
- Dec 2000
- Location
- NE Florida
- Posts
- 2,483
GM skipped zero's and O's in engine code sequences, for fear of confusing the two. The common spots to find #s are:
1. The right front pad of the cylinder deck (above the water pump port). These normally die on the first visit to a machine shop.
2. The block casting #s on the driver's side rear, TOP (to the left of where the distributor hole is, looking forward)
3. The cast # of a block- i,e; a "010" block, which is the high-nickle block. This alone will NOT ID a block's CID.
post your #s and I can use my Hollander to find it.
-
Reply With Quote
