The BAD AST Project - Faze II

[astroracer]

Thanks guys, The stickers are just for fun Martin, I have a few guys ask about doing some design work but, once it boils down to actually PAYING for the design work, nobody wants to do that.
Hey Will, yea the lift is a god send, as you will see in this post.
I worked on trimming down body mount bushings during the week and got the chassis centered up and aligned so Mel and I could get the mount brackets finished up and tacked on today. We got all of that done AND pulled the chassis out and put it back on the rotisserie AND took the van off the lift and rolled it over to the cold side of the shop so I can putter with it this winter. I hope you enjoy the pics.
Trimming the mounts. I set them up in the horizontal bandsaw and trimmed them down to one inch high.

This 7 of the 8 I did. I still need two more to finish them up.

After squaring up the chassis we measured how much we would need to notch the body mount brackets. 1" by 2" was the magic number.
Running the tubing through the verticle saw.

After getting all of the brackets ready I tacked them to the frame. We re-used the 6 old cradle mounts and added 4 new (two per side) towards the rear.


We fabbed up the rear mounts from 1/4" plate and some short sections of 2 x 3 tube.

These are just tacked right now. I am going to start the finish welding tomorrow.
As they look in the van.


We got the van off the hoist and onto the body cart. It sure did roll around nice.

My wife had a good time taking us for rides...

Once we got it rolled back in the shop we raised it up off the cart and set it on some jack stands.


The chassis is back in the shop. With body mounts! Have a few additional brackets to make and finish the welding. That will be tomorrow.

Thanks for looking
Mark