Ridetech 4 link opinions

[Sinnister69]

What hole do you have the lower bar mounted in on the axle bracket? I can't see that from the pictures. It should be in the middle hole to start with (if you have one of the older kits with an adjustable mount).

The tabs do sit a little farther back on the axle tubes, I wouldn't be too worried about that yet but we'll dig into it before you make everything too permanent. I've attached the best picture I can find from the old four link install pics. The 2* to 3* up pinion angle is good. Also, on the shocks, I personally would rather see them closer to the 14.5" mark if possible, that way you have a little more extension travel.

I'd like to see what axle tabs you ordered from us as well for the new housing. Can you send me an email with your name, address, or order information? It's [email protected].





Thanks,
Josh




***Edit*** Steve, I've been going through my emails from yesterday and just found yours with the pictures above. I didn't realize you had sent that over so I apologize for that. I do see that your mounts are non-adjustable so ignore that. I'm working on finding the tabs you have as well.

No problem Josh I know you are really busy so I posted here also.

I will send you an email with my info it has been a few years since i purchased the tabs for my own sake I believe I bough 2 of each size that I found on the site as Im not sure which ones were the correct ones