Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 8 of 8

    Threaded View

    1. #5
      Join Date
      Mar 2005
      Location
      Kansas City, MO
      Posts
      27
      Quote Originally Posted by Hotwire View Post
      I too vote not to put the fuse block in the trunk. That's a lot of extra wire / weight / complication.

      I really don't have room under the dash for the Coach Controls box or Holley PDM. I already have the ECU and Dakota Digital cluster box mounted there. I still need to mount the Dakota Digital boxes for OBD II, Climate Control, fan controller, and possibly TPMS. The beauty of the Holley PDM is that I can install the connector for the switches up front and then run an CAN BUS cable back to the PDM. Then I only have to run the larger load wires back up front. The Coach Controls box works similar in that the switches don't carry the load so I can run smaller switch wires to the back and again only have to run the larger load wires back to the front.



      I put the rear seat frame/springs in to check clearance on the battery cables. I'm ok on the back but the bottom frame is too close to the cables for comfort. I'm afraid over time that the seat frame will wear through the cable insulation. I'm in process of cutting the floor pan under the seat and installing a trough to allow for clearance. I'll make a cover to install over the trough to protect the cables and all should be good.





    Advertise on Pro-Touring.com