DCC PWM controller temp wire

[anguilla1980]

I'm getting ready to install my DCC pwm fan/EWP controller and I have a question about the terminal that connects at the thermostat housing.

What is everyone doing to hide this or make it look better? Having an eyelet coming off one of the studs doesn't exactly look good. First I'm going to cut off his terminal and use a non-insulated terminal and put some black heat shrink on it since the yellow plastic connector is very unsightly.



I guess from there I'm going to route the wire into my EFI harness where it connects to the coolant temp sensor. It's just that eyelet on the thermostat housing that bothers me.

Does anyone have any clever ideas on how to improve the look? I wish it could just connect to the coolant temp sensor signal wire instead of the eyelet.

Thanks!