Results 1 to 13 of 13
Thread: DCC PWM controller temp wire
Hybrid View
-
10-22-2020 #1
Registered User
- Join Date
- Sep 2016
- Location
- Bakersfield, CA
- Posts
- 600
Oh, so I need to leave the ugly yellow insulated connector on there and not replace it? I thought it was just a special kind of wire, not a special kind of eyelet.
Originally Posted by dhutton
I’m not quite following you but if the terminal you are referring to is the temperature sensor then you cannot just cut it off. It won’t work if you do....
Donhttp://www.TheFOAT.com/92GTA
1969 Pontiac Firebird w/BP 461ci stroker kit, 670 heads & XE274H cam. Primer black with black interior.
1992 Pontiac Trans Am GTA w/SLP Performance Package. Dark Jade Grey Metallic, grey leather, T-Tops.
-
10-22-2020 #2
Registered User
- Join Date
- Nov 2006
- Location
- Mountain Springs, Texas
- Posts
- 4,865
I honestly don’t know, just flagging that this might not be a good idea. Put black heat shrink over the ugly connector. Originally Posted by anguilla1980
I would tell you to contact DCC but that is not likely going to generate a response.
Don1969 Camaro - LSA 6L90E AME sub/IRS
1957 Buick Estate Wagon
1959 El Camino - Ironworks frame
1956 Cameo - full C5 suspension/drivetrain
1959 Apache Fleetside
Reply With Quote
