Bugzilla - Mid Engine Madness

[Bugzilla]

Looks like it wasn't mating evenly. Was everything bolted up with the correct order/torque?

I sure hope it was! I hand tightened all the pressure plate bolts a little at a time going in a star pattern. After the pressure plate was touching the flywheel on all 6 stands, I used the TQ wrench and did the final pass. It does seem like the pads have uneven wear on them. Is this not normal for a very very very low mile disk that doesnt really slip when releasing the clutch? Another odd thing is that my engine / trans combo does not use a pilot bearing.