Rear down bar question

[6DoF]

i have another post discussing the project, but this is a specific rules clarification question.

https://www.pro-touring.com/threads/...ll-bar-vs-cage

for the rear down bars, i am looking at the diagram below. the bars do not tie into any node on the cage, and they are bent in the middle. these slope away from the cage, then straight down to the floor. if i was to use the exact same bars, but flip them around, they would go straight down from the cage, and then slope down to the rear floor. exact same bars tied to the exact same points. i could then triangulate the bend into the harness bar for extra strength at the bend. this seems simple, but is there any specific statement in the rule book that would disqualify that execution?

the reason i ask is for the other picture below (not my truck but same thing). this would allow me to bring the rear down bars thru a lexan back window, instead of cutting up the top of the cab.