Matt:

Thank you for your reply. I was beginning to wonder if anyone would. I have adequate experience in calculating wheel rates and laying out suspension systems. I have built several late model race cars used for circle track racing. Some of these were big bar soft spring, some on bump stops. I have Performance Trends software that I use for my calculations. I say this not to showcase my experience, but rather to explain that I just did not know how much wheel rate to apply to a street car. Some of my cars would compress 5-6 inches on the track, while others didn't move.



With your 110 lb/in wheel rate, how much wheel travel do you see on the street? Is it harsh?

I am concerned with my allowed wheel travel in bump. I only have about 2". I am not sure if this is enough?

Bob