L & H Kustoms Spindles

[tonyvol]

Anyone running L & H Kustoms spindles? I was wondering if you've had any problems with them. I bought a set a while back but don't have the car on the road yet. I noticed that Marcus at SC&C doesn't appear to sell them anymore.

https://www.pro-touring.com/threads/...pindle+failure

Thanks,

[69cutlassrkt]

They may have gone out of business. Last time I looked their site was not up or wasn't there anymore.

[csouth]

Anyone running L & H Kustoms spindles? I was wondering if you've had any problems with them. I bought a set a while back but don't have the car on the road yet. I noticed that Marcus at SC&C doesn't appear to sell them anymore.

https://www.pro-touring.com/threads/...pindle+failure

Thanks,

That thread was the only failure that I've seen with this spindle over the years. I know Tom Farrington used to run some on his Chevelle years ago and he beats up on it pretty hard.

[tonyvol]

They may have gone out of business. Last time I looked their site was not up or wasn't there anymore.

Thanks Kyle, yeah I noticed the same thing. Not sure what happened to him.

That thread was the only failure that I've seen with this spindle over the years. I know Tom Farrington used to run some on his Chevelle years ago and he beats up on it pretty hard.

Thanks Chris, That's good to know. I would hate to have a spindle fail with all the money I've put into this car. I searched all over the internet and this was the only failure I saw reported as well. The front end of my camaro has a 2 in drop and I installed upper and lower control arm bump stops. Are you using L & H Spindles?

[csouth]

Thanks Kyle, yeah I noticed the same thing. Not sure what happened to him.



Thanks Chris, That's good to know. I would hate to have a spindle fail with all the money I've put into this car. I searched all over the internet and this was the only failure I saw reported as well. The front end of my camaro has a 2 in drop and I installed upper and lower control arm bump stops. Are you using L & H Spindles?

I don't have them, but I did order them originally from SC&C. Mark was having a terrible time getting them and I needed my car on the ground so I switched to the AFX spindles because they were in stock and shipping.

Back then when I talked to Luke on the phone he was divorcing plus he had changed the source of his machining. I think his volume wasn't big enough, so his stuff would get bumped when large orders would come in. I received my steering arms, but immediately returned them to Mark as I had told him to change my order.

I think you just need to verify that your parts work in harmony together and you should be ok.

[Chevelle598bb]

I actually have Tom's old L&H spindles. They haven't seen the road yet but hopefully soon.