Racepak IQ3 OBD2

[Catmanzr]

I want to use a Racepak IQ3 with OBD2 interface to get all my engine information for free. (Tach, volts, water temp, oil pressure, Speed.........etc). Does this work on newer GM LS platforms? Specifically a crate LSA with the GM wire harness and ECU?
I have scoured the internet looking for feedback if the ODB2 interface really works on newer GM vehicles. This has been released for 3 years now.......seems like someone would have some feedback. Are there and site sponsors that are racepak dealers I can call? Racepak was'nt all that helpful.



Any info greatly appreciated.....thanks Dan

[Catmanzr]

TTT.....anyone I can call? Really want to use one.

[andrewb70]

Have you called them?

Andrew

[Catmanzr]

Yes I have......all they say is theoretically it should work, but they don't have a list of cars confirmed.

Was really hoping to find someone with a LS platform that is actually using the obd2 module with the IQ3.........

[jlwdvm]

Any luck with your search? I'm thinking about going this way too.

[pist0lpete]

I imagine it's programmed to read the SAE standard PID's on the can bus for obd2. Therefore, it should read all the basic parameters. That said, that's an expensive mistake of it ends up not working.

[Kcorrigan2]

I want to use a Racepak IQ3 with OBD2 interface to get all my engine information for free. (Tach, volts, water temp, oil pressure, Speed.........etc). Does this work on newer GM LS platforms? Specifically a crate LSA with the GM wire harness and ECU?
I have scoured the internet looking for feedback if the ODB2 interface really works on newer GM vehicles. This has been released for 3 years now.......seems like someone would have some feedback. Are there and site sponsors that are racepak dealers I can call? Racepak was'nt all that helpful.

Any info greatly appreciated.....thanks Dan

I am trying to figure out exactly what you are trying to do...drive gauges with the IQ3? I have the IQ3 in my Camaro and all of the information you are looking for is displayed on the IQ3...you can even customize the screen to show what you want...or are you trying to feed your ECU with the information from the Racepak? I have a Big Stuff III and the Racepak gets its information from there.