Need Help Removing Hydraulic Line From Slave

[ATAK, Inc.]

Time for the dunce cap here, How do you get the hydraulic clutch line disconnected from the throw-out bearing/slave at the bell housing. I removed the white nylon split bushing but I can't get it to do anything.


HELP, please!

[s4dustin]

Time for the dunce cap here, How do you get the hydraulic clutch line disconnected from the throw-out bearing/slave at the bell housing. I removed the white nylon split bushing but I can't get it to do anything.


HELP, please!

You use the nylon split bushing...to push in the teeth off the slave and then pull. It is a little tricky. I did the same thing, taking the nylon off. Keep it on and push in into the slave. It is a little tricky, be patient and try not to break it.

[ATAK, Inc.]

You use the nylon split bushing...to push in the teeth off the slave and then pull. It is a little tricky. I did the same thing, taking the nylon off. Keep it on and push in into the slave. It is a little tricky, be patient and try not to break it.

Thanks Dustin, I have lots of patience, most of the time! I'll let you know how it goes.