MP Rear Disc Brake Conversion Kit - Legend Series

[TomsResto]

Will be swapping out my basic rear brake conversion kit (on GM 10 bolt) with a Wilwood set to match the fronts I just put on this past summer. I'm not sure if "protocol" here is to wait until the parts are off the car before I post on the for sale section or if it's OK to post something like this for someone who is in the middle of their own build and is OK with waiting a few weeks/months until I find the time to get my work done in pulling them off.

Based on the build paperwork the original owner/builder provided it appears the rear setup is the kit from Master Power Brakes:
http://www.mpbrakes.com/rear-brake-c...-legend-series

The calipers have been painted GM blue to match the lower portion of the body on the car

The kit only has 3,000 miles on it

They are drilled/slotted which would put them about $700 new ... first $350 (plus shipping to send them to you via big brown truck) takes them once I get them pulled off (the absolute latest I would pull them off would be May 2017 before Power Tour, but hopefully I'll get my other projects done on the car quicker than that and have them off sometime in March/April)

I'll post a picture of them once I find them on my phone/computer from awhile back when I was doing some general maintenance/cleaning and had the rear wheel off.

[TomsResto]

[TomsResto]

OK... this isn't very pretty... but I live in the midwest and havent' been able to drive it to let the brake pads clean back up the face of the rotor after giving her bubble baths.

[TomsResto]

Should state also that I have the replacement Wilwood kit at the house, so I am replacing these... the money is spent.

It's just a matter of when I get the time to do the swap with work, family, life activities during the cold winter of Iowa when the car sits in the garage in hibernation.

[Mofoe73]

sounds like they are only for 69' Camaro 10 bolt or do you know if it will fit a Chevelle 10 colt?

[TomsResto]

sounds like they are only for 69' Camaro 10 bolt or do you know if it will fit a Chevelle 10 colt?

I don't know for sure, and don't want to mislead you... but I added this set to my shopping cart out on their web site and then added a 69 Chevelle kit to shopping cart and then it shows both as being the same part number, same price... leading me to believe they are identical.

[TomsResto]

[TomsResto]

OK, these are off the car now... and ready to go.

However, I'm going to be completely honest and state that we have our questions about whether each caliper was working as it should... we suspect the one that was mounted on the driver's side was having issues with the emergency brake adjustment.

So at this point half of new doesn't seem fair if I don't have absolute confidence in the parts I'm putting up for sale.

So make me an offer, based on what the full set would run new... rotors, calipers, brake pads (car has less than 3k miles on it after the original build from previous owner who installed this disc conversion), soft jumper lines (caliper to hard line on the axle), etc.

I'll post pics of the pieces off the car and can take a close up of something else if folks want to see something specific.

[TomsResto]

[TomsResto]

Calipers (better images showing color in images posted earlier) and related mounting brackets, pads, etc.

[TomsResto]

Any interest from anyone out here before I set them out at a local swap meet here sometime soon?

[TomsResto]

???