69' Camaro Help Request - Replacing Rear Quarters, Trunk, Tail, etc.

[JohnnyProTour]

Hi Everyone, I am working on a 69' Camaro and need some help. A little history on the car; I bought the car about 10 years ago from the original owner. The car is a Plane-Jane with a 307, 350 AT (drivetrain has been replaced). The car was hit in the right rear quarter and has been re-painted when the 1st owner had it. Currently, the car is completely gutted and sits on a body dolly. Due to the previous work done and rust issues in the rear sections, it was decided to replace the quarters, right rear outer wheel house, full trunk pan and rear taillight panel.

On to the problem at hand (not really a problem, just need so help with verifying some measurements). I have installed all new sheet metal as mentioned earlier and everything fits ok. However, I would like to get some verification measurements from the center of the inside bottom of the trunk pan to the top of the Deck Filler Panel Assembly lip (Rear Window to Deck Lid) as shown in the picture. I would think that this measurement would be the same for all 1st gen Camaro's.

Any and all help is appreciated.

Thanks
John

[mikey]

Not seeing a pic but I'm using the mobile version I can measure mine tomorrow night for you

[corvettekid1973]

On the mobile application click on the paper clip on the top right Then click the black box with the check to see his pic

Not seeing a pic but I'm using the mobile version I can measure mine tomorrow night for you

[mikey]

On the mobile application click on the paper clip on the top right Then click the black box with the check to see his pic

Not seeing a pic but I'm using the mobile version I can measure mine tomorrow night for you

I got it to work tonight just brought up a blank screen last night