Twist Machine Paddle Shifter

[BlackHD]

Hi,

I was I wondering if anybody has had any experience wiring the Twist machine paddle shifter to the holley dominator.

Attached are the Twist Mahine instructions for the Compushift controller...I'm uncertain as to where to connect the white common wire to the dominator.

Any help is appreciated.

http://www.twistmachine.com/content/ShrifterInstallation.pdf

thanks!177266

[andrewb70]

Hi,

I was I wondering if anybody has had any experience wiring the Twist machine paddle shifter to the holley dominator.

Attached are the Twist Mahine instructions for the Compushift controller...I'm uncertain as to where to connect the white common wire to the dominator.

Any help is appreciated.

http://www.twistmachine.com/content/ShrifterInstallation.pdf

thanks!177266

I don't know this for a fact, so that that for what it is worth, but my guess is that the white (common) wire should go to one of the Dominator sensor ground pins. Consult the Dominator pin-out map, as there are multiple available sensor grounds on all of the Dominator connectors.

Andrew

[WOLF1732]

what transmission are you controlling ?

[BlackHD]

Hi Andrew, so it would be an sensor ground "output" from the dominator?

thanks for your help.

Hey WOLF1732, its a 4l80e.

[andrewb70]

Hi Andrew, so it would be an sensor ground "output" from the dominator?

thanks for your help.

Hey WOLF1732, its a 4l80e.

Yes, but again, this is purely speculation.

Andrew

[BlackHD]

Great thanks, I'll give it a shot.

[andrewb70]

Great thanks, I'll give it a shot.

Also, I do remote Holley EFI tuning and can consult on other wiring issues. Shoot me a PM if I can be of service.

Andrew