Alignment turntables, where to get a pair?

[pitts64]

Who has a good deal on alignment turntables?

Thank you,
Jeff....

[Schwartz Performance]

Only ones i've ever seen are all pretty expensive.. I've seen some DIY turntables in the past, google that.

http://www.summitracing.com/parts/sps-99750/overview/

[Ron Sutton]

Who has a good deal on alignment turntables?

Thank you,
Jeff....

Hi Jeff,

I carry 3 brands around $700 a set. You can see them HERE (http://shop.ronsuttonracetechnology.com/shopping/?ic=9342). I prefer & use the Joe's Racing, as their stuff is always super nice & well made.

Best wishes.

[MonzaRacer]

a quick note you could also use 2, 12 in square 1/4" thick pieces of lexan, get a counter sunk allen head bolt around 3/8 or 7/16 drill and helicoil bottom piece use white lithium grease between and only tighten up screw enough to hold them together, trim bottom of bolt flush and tada. Ill see iff I can find the actual set of plans i have.
also look around on Ebay, wheeltronics, John Bean, Hunter, and several others all use same balls for replacement and looking up Stempf part number and googling can get you new balls easy enough as long as rings and springs inside are good.

[eric1967]

Check some of the older auto or tire shops. I bought a set from a local tire shop that had been there for years.

[regal454]

I made my own using 2 pieces of 12x12 aluminum with wheel bearing grease between them...works perfectly!

[dhutton]

I got a set for a good price on eBay. Not the best but I don't use them a lot.

Don

[Rick Dorion]

Ebay for me too. I've done about 6 alignments on a few projects and this fits my needs. It was a couple of years ago but I believe I paid about $100 plus shipping. Again, they're cheap but suitable for my home hobby need.

[Buryingthesun]

I built a set, 12"x12" 1/4" steel plates and trailer hubs with bearings. . . its hood as f*ck lol