Activity Stream
-
Older Activity
-
8 Hours AgoI've got a 68 Camaro and recently purchased the RideTech gas cap kit. My question is do I need to vent it?2 replies | 31 view(s) -
9 Hours AgoHi, I am a restoration and custom build shop owner in Connecticut and I'm excited to be part of the forum. We started out with a general focus on...1 replies | 15 view(s)
-
6 Hours AgoSTREETFIGHTER50 started a thread Why does BluePrint Engines say to not go synthetic until 9000 miles?? in Engine MiscellaneousA car I’m getting soon has a new (1400 mi.) 530hp LS3 crate engine from them. I always thought that after initial break-in, 500–1000 miles would be...0 replies | 35 view(s) -
3 Hours AgoForgeline Wheels started a thread Angel Palacio's 1956 Chevy Truck on Forgeline Forged Three Piece GA3C Wheels in Wheels & TiresThey call it "Pitch Black". Angel Palacio’s 1956 Chevrolet 3100 truck originally belonged to his father and was transformed into this modern...0 replies | 19 view(s) -
6 Minutes AgoI didn't want to run the full length of the car with hose4 replies | 114 view(s) -
6 Hours AgoBack from the dead again: I did it. And now I'm doing it for other people too. If by chance you are interested, shoot me an email at...6 replies | 8326 view(s)
-
6 Hours AgoMarc, Welcome to the site. It sounds like you build some pretty cool rides. Before we get too far into this we may need to chat. Promoting...1 replies | 15 view(s) -
6 Hours AgoYes, that is non vented cap.2 replies | 31 view(s)
-
8 Hours AgoI've got a standard tank with a 350 SBC. Would appreciate any advice…2 replies | 31 view(s)
-
10 Hours Agochevyz240 replied to a thread "Mechanix Menace": An LS7-motivated, chopped and heavily modified 1973 Datsun 240Z in Project UpdatesA little while ago, I welded in the last pieces of the hand shaped rear wheelwell corners. Today I went to https://www.autocut.se/. There, Håkan...493 replies | 359626 view(s) -
13 Hours AgoThank You Bob!58 replies | 30882 view(s)
