Components to mate an LS427/570 and T56...

[roguegeek]

If that's the case, I'd just get the LS7 from Pace and give Craig at Bowler a call for the rest.

I'm not quite sure where the disconnect is here, but that's not my question. I've already decided on motor and trans as well as where I'm purchasing from.

[andrewb70]

I'm not quite sure where the disconnect is here, but that's not my question. I've already decided on motor and trans as well as where I'm purchasing from.

You need a flywheel and clutch, as well as a bell housing. You will also need a hydraulic TOB and the hydraulic MC at the clutch pedal.

Andrew

[roguegeek]

You need a flywheel and clutch, as well as a bell housing. You will also need a hydraulic TOB and the hydraulic MC at the clutch pedal.

Thank you. Are there any recommendations out there for a flywheel, clutch, and bell housing?

[andrewb70]

Thank you. Are there any recommendations out there for a flywheel, clutch, and bell housing?

Depends what's important to you. Many people, including me, like the LS7 clutch, however, it is rather heavy. The weight makes it drive nice, but isn't optimal. Same for the bell housing. I like the stock forth gen Camaro bell housing, but others prefer the steel QuickTime.

Andrew

[roguegeek]

Depends what's important to you. Many people, including me, like the LS7 clutch, however, it is rather heavy. The weight makes it drive nice, but isn't optimal. Same for the bell housing. I like the stock forth gen Camaro bell housing, but others prefer the steel QuickTime.

Thank you for your feedback. Since this discussion is getting more specific now with bell housings, I'll make a post on the proper forum to continue.