67 camaro project

[Prayingmantis]

Hello new here, im building this car and have already made progress ill post as many pictures to catch up to its current state. I do alot of fabrication and electrical diagnostic I know alot but not everything and would love input or criticisms I know there are incredibly smart people here so if im screwing up please let me know. And go easy on me with my body work I'll be posting all the pictures

[Prayingmantis]

This is how I bought the car I had even cleaned it before this picture. And the next car I get will be farther along than this one that's for sure!

[Prayingmantis]

Trying to straighten everything i can before I start skim coating

[Prayingmantis]

Dash panel was bad so it had to go rust was forming in the corners.

[dhutton]

Impressive work straightening that metal!

[Prayingmantis]

Thanks man body work is definitely not my favorite!

[Prayingmantis]

Small amount of rust on the lower quarter had to cut it out.

[Prayingmantis]

This was truly the worst part of my whole life! I have never done bodywork and im not doing it again at least this amount .

[Prayingmantis]

Attachment 220907Attachment 220908Attachment 220909Attachment 220910Attachment 220911

Sprayed spi epoxy primer on her. I do realize I should have sealed the sheet metal before filler work but at this point im over it.

[Prayingmantis]

Two coats and it laid down really good

[Prayingmantis]

Got the moser housing, currie 3rd member, 4.11 gears, helical posi completed and put 2014 zl1 brakes on the rear calipers will be swapped out to ctsv calipers (there the same)

[Prayingmantis]

Made a new rear harness. Added speaker wire and 12g fuel pump wire as the core all tefzel wire. Used the original plug but kept enough slack in case I want to change plugs.

[Prayingmantis]

did some mock up and caliper needs to go rearward

- - - Updated - - -

is there a way to make the pictures normal like up and down not sideways?