Need a little help figuring something out

[SSLance]

Lance,

Curious how did you do it when you went back and measured again without the bottle jacks to get suspension at ride height?

After putting the car back down on the tires, I just had to get more creative with where and how I placed the laser levels to get the measurements from. Using the framing square with welding magnets to hold it true and square helped a lot to get into the tight spots.

Plus I wasn't as overwhelmed as I was in the beginning because I had already made all of the measurements once and pretty much knew what I needed and where to go to get them.



When starting from scratch, I was pretty frustrated fighting around the tires trying to get the first couple of sets of measurements. Over time I developed ways to get around things that made it easier to get around obstacles.

[diesel25lrs]

Thanks Lance,
I'm thinking that without lift access it will probably be worth it to just fab up some hub mounted stands of some sort...up and down adjustability will be key though.